Fan Light Remote Control Not Working

Replace it with a universal model or get a replacement recommended by the fan s manufacturer.

Fan light remote control not working.

Follow the steps below to determine the cause. First ensure that the mains power is turned on and then check to ensure that the circuit breaker for the unit is not. Similarly try to turn on the light by using the remote. Within 30 seconds use a small screwdriver to press and hold the learn button on the remote for 3 seconds.

Yes the ceiling fan remote control module may be faulty. When to buy a new ceiling fan. The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high. If you cannot get the fan to turn on at all using the remote pull on the pull chain and set the fan to the highest speed.

If the remote control of your fan is not working here is what you can do to try and fix the problem. Confirm the reverse switch is not in a neutral position. One way to know for sure would be to remove the receiver module at the ceiling fan and wire it direct. Flip the switch several times to make sure it is the right.

Turn the ceiling fan off. Remove the batteries from the remote control and wait for about 10 seconds. If you have an older ceiling fan the switch may be worn out. If it will turn on the fan but not the ceiling fan lights try resetting the remote control.

If fresh batteries and altering the settings on your fan receiver and remote did not work you may have a damaged remote control. Now we know the buttons don t work did you try to change the battery. Below are troubleshooting steps to follow. Ensure that the fan s receiver and dip switches behind the remote are on the same frequency.

Replace the batteries in the remote control and turn the power back on. Replace your ceiling fan remote. Check to ensure that the problem is not with the remote see fanimation remote not working guide above if the mains supply circuit. The fan will turn on and light if applicable will blink three times signaling a successful synchronization replacement remoteif the fan works without the remote via a pull chain or switch but not with the remote even though they have the same settings the remote has probably gone bad and you will just have to get a replacement remote.

So if the pull chain is in the off position the remote control will not be able to get any power to the ceiling fan light or fan. Test to determine whether the batteries are dead. Remove the back of the batteries to check if you have inserted them correctly. If no luck turn on the light by pulling the light pull chain.