How to fix drywall where a rod bracket pulled out 1.
Fix curtain rods drywall.
Insert a 3 16 inch drill bit into a power drill and.
You can be confident of hanging curtains without damaging walls.
Using drywall anchors is the only solution.
There s several ways to fix this depending on a few things.
You ll have to patch up these holes which may be a bit of a pain to do with the textured walls but it s doable.
Mix about 1 2 cup of patching.
Tap the curtain rods mounts with a hammer on a hard flat surface to.
Follow up with a coat of drywall joint compound to the patch and spread it.
If you mount a curtain rod with a screw over time you will end up with a sagging curtain and hole.
If there s one close enough that it looks okay you should do that.
A toggle bolt fits through the drywall and a spring loaded wing nut opens up and securely locks the bolt in place.
The best thing to do is avoid drywall anchors and screw directly into a stud.
Make sure it fills the gap evenly and don t bulge out.
First drill your hole using an electric drill.
Make sure the newspaper wedges.
When attaching a towel bar curtain rod drape bracket or toilet paper holder into drywall the best type of wall anchor to use is a toggle bolt.
Push the rod through your curtain if the curtain has eye holes.
Tear off all the loose paper around it.
Clear out the hole with a flat head screwdriver.
You ll need to get the curtain on the rod before you hang it unless you re using rings.
Give it about 20 to 30 minutes to harden.
How to fix a curtain rod 1.
Remove the curtain rod from the rod mounts.
Locate the damaged drywall where the curtain rods were mounted.
Tap a small plastic anchor.
In order to install it the screw is brought through the little hole on the rod holder and then holding the toggle bolt together push it into the same hole on the wall.
Unlock the curtain rod ends and get a friend to help you extend both sides of the rod against the walls.
Drywall will not hold a screw because it s not solid.
If using rings put them in place on the rod now.